CXBOX ECOSYSTEM WEB TOOL
Step 1: Connect Device
Please connect your chip board to your computer with a data cable.
- Browser: Chrome or Edge on desktop
- Cable: USB data cable (not charge-only)
- Close tools: Arduino IDE / PlatformIO / other serial monitors
- Driver: CP2102/CH340
Install complete
Start an online trial now, or buy to get your license key and unlock offline use.
Online trial
Start a guided trial session on this device now.
Buy license key
Get your key and unlock offline use.
Browse below, or select with your purchased license key.
—
—
—
Review this firmware before you continue.
Choose firmware
Search the full catalog when the workspace dock is not available.
Trial runs only while this page stays active. Switching tabs or closing the page stops the online heartbeat and the device will lock.
Trial will flash the ... firmware to your device.
1. Wiring
Connect the board to your computer with a USB data cable. Wire GPIO to buttons and status LEDs if your build uses them.
2. Camera pairing
On your Blackmagic camera, open Setup → Bluetooth → On so the device can pair over BLE.
3. Control
Use physical buttons, or open Advanced in the footer for the serial console to send test commands.
Offline mode (optional)
- → No browser tab / heartbeat required
- → One-time activation bound to this device ID
- → Safe for long sessions
Generate an NVS payload to preview the config.